EUR153,75
Fellowes Platinum Series Triple Monitor Arm
Table, 27", 7 kg
Questions about Fellowes Platinum Series Triple Monitor Arm
What would you like to know?
0 questions and answers
Helpful answer
Exactly.
Helpful answer
The side monitors are adjustable, you can definitely align them with the central monitor or move them if you wish.
The Fellowes triple arm is officially only designed for up to 27″ / max. 7 kg per monitor - there is no guarantee for 28″.
Better: a mount up to 32″ / approx. 8 kg per arm, e.g. Huanuo Triple Monitor Mount (17-32″, approx. CHF 85, Galaxus) or ELIVED Triple Monitor Mount (17-32″, Amazon).
Galaxus
7 months ago
Monitors with a size of 28 inches cannot be recommended as the mount is designed for monitors up to a maximum of 27 inches. The maximum monitor size is 27 inches and the load capacity per arm is 7 kg.
Automatically generated from the . Helpful answer
Yes, it's all there.
Helpful answer
I would say according to my measurement max. 3.5cm
No. One at the bottom and two at the top is possible. To mount one on top, you need an extension for the tube.
That's a damn good question...
I could try to measure the spacing of the holes when I'm in the office, don't know if that's a given and that's why it won't work.
Otherwise I wouldn't see a problem, you can pull the arms apart quite nicely, so the width of the screen per se shouldn't be a problem.
Helpful answer
Hey,
I have 27" curved on the left and in the middle, but I had to turn the middle bracket to the right to adapt the left screen to the curved "curve", arm left is max. extended. On the right, it is therefore no longer possible to mount another 27", but I have no problem with this as my right one is upright.
To cut a long story short, I don't think you can mount 3x 28" at an angle.
greez
The one you screw on vertically is definitely the other one could be tight.
Helpful answer
*Gaming
Yes, you can. All screens can be individually rotated 360 degrees on a vertical plane.
Former employee
5 years ago
According to our information, the 30" specification is correct. It is possible that you received the wrong product, which is of course not in our interest. It is best to contact our customer service directly (digitec@digitec.ch). Your order can then be checked individually.
According to our information, there is only the clamp.
In the middle this should not matter, it depends more on what is on the other arms and the total force that presses on the table. Possibly make sure that the table cannot fall backwards.
Former employee
7 years ago
You would have to try it out effectively and unfortunately we don't have anyone in the office who uses this triple monitor arm. However, according to my telephone conversation with the supplier, it should be possible, purely from the joints, to put the middle monitor down and a monitor over the arm above it. And just one monitor to the right or left of it.
19 of 19 questions