Designed for controlled and safe pulling with a pressure force of 10 t, 12 t, or 15 t. The pressure piece can be replaced with a tip and extended if necessary. The small pressure spindle is secured with a locking mechanism to prevent unintentional unscrewing.

Preparation for Use:
1. Before use, check that the pressure spindle is screwed out far enough from the cap so that the pressure piece is in the starting position within the hydraulic cylinder.
2. Unscrew the cap from the spindle body. First, loosen the threaded pin.
3. Screw the spindle body from below into the puller's traverse until the spindle body protrudes approximately 60 mm from the traverse.
4. Screw the cap onto the spindle body until it stops, and then secure it by tightening the threaded pin.

Operation and Working Method: e.g., HSP3
5. Position the puller and pre-tension the spindle body with a SW 41 wrench.
6. Screw the pressure spindle SW 17 into the cap. The hydraulic system is activated. The stroke of the pressure piece in the hydraulic cylinder is a maximum of 12 mm. The hydraulically released workpiece can be completely pulled off by turning the spindle body with the cap SW 41.
7. After use, the pressure spindle SW 17 is turned back to the starting position, and the pressure piece is pressed back into the hydraulic cylinder.