Hello, I am actually quite early with my Braava Jet m6, however after 4 to 5 cleaning tasks it has a problem. It starts a new task normally, cleans normally for a short time. Suddenly it stops and a sound is heard, then a red light circle appears briefly and then it is like in standby mode. After a restart, it starts all over again. So the only thing I can do is to reset the Braava to factory settings. This is stupid in the long run, because the mapping is always gone. I have seen that Braava is still running under firmware 3.10.8. In the meantime there is a newer one. I have already tried everything, but Braava does not want to update. What could be wrong? How can I fix the error? How do I get the new update on? Thank you very much. Greetings Anita Allmann