I have Wingo and would like to use the FritzBox 5490. If I set the provider to Swisscom, I get the full 1Gbit/s, but I always have the Swisscom splash page when calling up websites. I can't find DHCP option 60 anywhere on the box. Setting a VLAN ID is also not possible.

If I activate the advanced settings, select another provider and set the VLAN ID to 10, I have Internet but the problem is that I only get 100 Mbps in the WLAN and via cable. In the settings, the value is set to 100,000kbit/s.

Does anyone have a solution?

Kind regards Whoisfoxmulder

Question

I have Wingo and would like to use the FritzBox 5490. If I set the provider to Swisscom, I get the full 1Gbit/s, but I always have the Swisscom splash page when calling up websites. I can't find DHCP option 60 anywhere on the box. Setting a VLAN ID is also not possible.

If I activate the advanced settings, select another provider and set the VLAN ID to 10, I have Internet but the problem is that I only get 100 Mbps in the WLAN and via cable. In the settings, the value is set to 100,000kbit/s.

Does anyone have a solution?

Kind regards Whoisfoxmulder

Accepted Answer

First download the latest firmware from http://download.avm.de/fritzbox/fritzbox-5490/other/fritz.os/ and then install it on the box.
Under the Fitzbox settings in (activate Expert mode) --> Internet --> Access data --> Provider: iWay Fiber --> Access type: iWay Fiber CH DHCP (VLAN10)
Wingo works for me with the access type: iWay Fiber
It is also important that you use the correct fibre optic cable for the box.

Your data. Your choice.

Search

Question about AVM FRITZ!Box 5490 Fiber