High-quality stainless steel loading edge protection for VW Golf 6 sedan from 2008 to 2012.

This loading edge protection made of brushed stainless steel protects the rear bumper from mechanical damage that can occur during loading and unloading. Thanks to the specially profiled edge, the bumper's edge is also protected.

Ideal as a protection for the bumper or to cover existing scratches.

• The strip is mounted over the rear bumper
• Material: High-quality brushed stainless steel
• Absolutely rust-free
• Adhesive strips attached to the back; can be applied in just a few minutes
• Vehicle-specific, highest precision fit with edge
• Elegant and modern appearance
• Visual enhancement of the vehicle's rear

Installation instructions:

• Before removing the protective film from the adhesive tape, check that the loading edge protection is intended for the area to be covered.
• For installation, it is important that the surface to be covered on the vehicle is clean, dry, and grease-free.
• The loading edge protection is applied using the pre-mounted adhesive strips on the back.
• Ensure that the loading edge protection is aligned flush from the start. To center it, you can use the alignment notch of the lock on the trunk floor as a guide.
• Then press down several times, and you're done!.