Cat flaps + Cat nets

5 threads in Cat flaps + Cat nets

Start thread
  • Avatar
    gilbert 4 years ago in Cat flaps + Cat nets

    Difference cat flap CAT MATE

    What is the difference between the two cat doors? - Cat Mate Elite Selective Cat Door Article 6204093 - Cat Mate Elite microchip cat flap with time control Article 7014607 Which of the two cat flaps corresponds to the manufacturer's reference Ref. 305, or Ref 355?

    Avatar

      1

  • Avatar
    PC24PC24 3 years ago in Cat flaps + Cat nets

    Petwalk

    I also had a cat flap. But it was bad in wind storms, it was half open, and in winter the thermal insulation and air-tightness were poor. I now have the petwalk.at cat door. It is really expensive but also really good. Heat-insulating, airtight, works with a motion detector or chip. However, I did not buy the internet module because it is a free run on the balcony.

    Avatar

      1

  • Avatar
    ZEROX 2 years ago in Cat flaps + Cat nets

    Cat Door With Chip Reader

    So here's the thing, I have 2 cats 10 and 11 chipped, I now have 22 kittens that are not yet chipped and I would like to let the big ones out but not the little ones, is there a cat door that reads the chip when I go in and out?

    Avatar

      1

  • Avatar
    Bärimanni 3 years ago in Cat flaps + Cat nets

    Diameter of opening in glass door = not specified

    Dear Galaxus team We already have a cat door, so we also have a glass door with a matching round hole. But in your offers there is no information about the necessary diameter of an opening. I can't order like that, sorry.

      0

  • Avatar
    kunostoeckli 5 years ago in Cat flaps + Cat nets

    Wrong size

    We previously had a cat door with a size of about 24cm x 25cm. The description says width 24.1 and height 25.2. The delivered product was about 22cm x 22cm => That's why we had to return it. @Galaxus: Please enter the correct description or send the correct product!!!

    Avatar

      1

Order of
discussions
Forum for Cat flaps + Cat nets
PostStart thread